factories that make accessories for electronic products know that,

cut this step, it seems simple,

But the requirements for precision are often much higher than imagined.

unlike ordinary materials,

once there is a deviation in the accessories of electronic products,

problems don't erupt on the spot,

but will be enlarged in the back.

• is a little off, and the back is completely misplaced.

products like double-sided tape, conductive materials, insulating sheets,

have to fit with other parts.

If the cutting size is deviated:

difficulty in counterpoint

poor fit

even directly scrapped

sometimes it's just 0.5mm short,

will not be used.

• accuracy is not just "size", but also consistency.

many factories will find:

a single product looks fine,

but a batch down, the error is not uniform.

this is essentially cutting stability is not enough

electronic products is not that they are not allowed occasionally,

, every knife is "different".

• Why is it easy to have problems with ordinary cutting methods?

Because electronic products accessories usually:

thin material, many layers (composite structure)

is very sensitive to pressure changes

if the equipment control is not stable enough,

is easy to appear:

partial cutting, rough edges, slight size drift, etc.

• ?

is not just raising the pressure,:

👉Uniform pressure control, stable and high repeatability

especially in continuous production,

can "every knife be the same",

is the key.

if you do now electronic products accessories cut:

often poor fit

or size

can reply.Accuracy Analysis],

we help you analyze which link is the problem